PRP 7053 Pair Header Tether Brackets NHRA Accepted Quantity 2

PRP 7053 Pair Header Tether Brackets NHRA Accepted Quantity 2

This listing is for two (2) PRP 7053 header tether brackets - collector tube clamp, primary tube clamp, header tether shown in second photo are sold separately.

The NHRA has made the following requirement: All removable multi-piece exhaust collectors/stacks must be securely fastened with either an NHRA-accepted header tether or a minimum ½” (half-inch) stitch weld located on each primary tube to prevent loss of collector/stacks during competition. On cars with a complete exhaust system (including but not limited to mufflers, hangers, flanges, etc.) that are securely attached to the vehicle, header tethers will not be required. All other exhaust systems must conform to the rule as written.

• Includes two (2) PRP 7053 header tether brackets
• These machined aluminum brackets attach to the clamps for easy installation
  
• The machined brackets are equipped with a removable shoulder bolt so you can remove the tether without taking off your tube clamps
  
• NHRA Accepted Product
  
• For a complete system as shown in the installed photo a primary tube clamp, header collector clamp, wire tether and two (2) tether brackets are required for each header
• Contact us to list a complete system using your size and quantity requirements