Zeitronix ZAVT-1 Audio Visual Warning and Trigger box

Zeitronix ZAVT-1 Audio-Visual Warning and Trigger box

Configure the Zeitronix Zt-2 Wideband to watch the gauges for you and you may save your engine.  Wired up with a relay the ZAVT-1 can trigger boost solenoids, nitrous, or methanol injection! (relay not included)  For use with the Zt-2 Wideband warning output. The ZAVT-1 is compact: 1 3/8 inches square by 3/4 inch thick!  Includes wiring harness. Made in the USA.

Please check compatibility with your Zeitronix Zt-2 Wideband System prior to purchase:  ZAVT-1 is compatible with the Zt-2 Wideband AFR Meter REV 9 or higher.  Zt-2s purchased after May 9, 2006 are compatible and support Simple Warnings. Zt-2s purchased after September 1, 2006 support both Simple and Complex Warnings.

The ZAVT-1 features a loud 95dB audio buzzer with a bright red LED.  A relay trigger signals the alarm. Relay available separately.

Applications:

• AFR too rich: The alarm activates when too rich mixture is detected
• AFR too lean: The alarm activates when too lean mixture is detected
• A combination of AFR too rich and AFR too lean alarms can be used to tune for a specific AFR window
• EGT too high: The alarm activates when EGT exceeds a safe user selected level
• RPM too high: Shift-light functionality with a bonus of audio alarm and a relay trigger
• TPS too high: The alarm activates when TPS exceeds a selected level
• USER1 Input too high: The alarm activated if a sensor connected to the USER1 input exceeds a selected level
• USER1 Input too low: The alarm activated if a sensor connected to the USER1 input is lower than a selected level
• Relay trigger: Open or close a relay circuit to activate or deactivate additional devices at a set warning level: Typically used to add a control to your boost setting, nitrous or alcohol injection and other devices.

The Audio Visual Warning and Trigger Box alarm is activated by Zeitronix Zt-2 Wideband AFR Meter. The audio alarm can be deactivated by adjusting the switch SW1 inside the box. The visual alarm and a relay trigger are always active. The ZAVT-1 blue wire connects to the Zt-2 Warning Output (white wire with a blue stripe).